Hello. I appllied that schematic and have the following behaviour.
DP83867E link established LED is on (after connecting the cable).
DP83867E link activity LED blinks once a few seconds (it doesn’t blink in sync with any other LED on the switch)
I connect a device to the switch and the device sees the ethernet connection but can’t ping any other device connected to the switch.
I am using port 9 but I have three DP83867E connected to port 0, 9, 10 through SGMII and I would like to use all three with 10/100mb/s devices.
I cut the solder jumper SM1 according to Getting UbiSwitch ports working with a 1G SFP
How should I proceed from now? (both to get working port 9/10 and port 0)